FECISION focuses on custom injection molding: part and mold DFM, injection mold tooling, specialty molding processes, production molding, finishing, and assembly under one coordinated engineering workflow.
Precision plastic and liquid silicone rubber (LSR) injection molding, including insulator and structural components, connector parts, and metal- or plastic-insert overmolded assemblies, with material and process matched to each part's function.
View Services →Mold tooling at Fecision is built and maintained in-house, not outsourced — covering production mold steel, wear-critical coated inserts, and rapid tooling for pre-production validation.
View Services →LSR, cleanroom, insert, overmolding, two-shot, gas-assist, and large-part injection molding for application-specific geometry, materials, sealing, and cosmetic needs.
View Services →In-mold decoration and labeling, molded-part surface finishing, and assembly coordinated with tooling and molding under one production plan.
View Services →CONNECTED BY ONE DFM TEAM
Mold shop and molding floor operate as one unit, so cavity polish, coating, and tooling are controlled on the same tool that runs production, not handed off to a separate vendor.
Rapid and production tooling use the same design data and DFM team, reducing handoff risk before production molding.
Mold wear is tracked, not assumed — coated inserts are built to hold dimensional and cosmetic consistency across long production runs.
Design data is covered under ISO/IEC 27001:2022 information security certification from the first prototype through production.
DOCUMENTED QUALITY
We employ rigorous validation protocols, including in-process and final CMM inspection, steel certifications, heat treat certifications, and comprehensive mold trials (T1, T2...) to ensure our mold performs flawlessly and meets all specifications from the first shot. Trust our ISO-certified quality system.
Either. Fecision's DFM team can carry a project from rapid tooling and mold trials into production injection molding, or a project can start with a production mold or an existing validated tool.
Yes. Mold tooling can be purchased on its own, with full DFM support, design drawings, and trial-run guidance, so the mold can run in-house or at a third-party molder — molding doesn't have to be bundled in.
Injection molding covers engineering thermoplastics and elastomers including ABS, PC, POM, nylon, PEEK, TPU, HDPE, PP, PET, PMMA, rubber, and project-qualified liquid silicone rubber (LSR). Material choice is matched to the part, environment, and validation requirements.
It depends on the stage a project is at and what still needs proving. Send part geometry, material, target volume, and project stage, and Fecision's team will recommend the right service or combination.
Send part geometry, material, target volume, and project stage, and Fecision's team will recommend the right service or combination.
Start a Project